FEATURES
- Capable of reducing up to 90% of radiant heat
- Adhesive backing sticks to almost any clean surface
- Helps shield fuel lines, brake lines, wire looms, and more from radiant heat
- Bulk rolls and custom widths available, minimums apply
- Made in the USA
Product Codes
#340001 1-1/2 in x 3 ft
#340020 1-1/2 in x 20 ft
#340250 2 in x 50 ft
#340410 4 in x 10 ft
#721150 0.032 th x 12 in x 50 ft Roll
Installation Tips
Cuts easily with heavy scissors or utility knife
Thermaflect Tape is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source
Panel or component surface temperature should be at least 65°F, sticking onto anything colder may not allow adhesive to set up properly.
Degrease and clean surface any residual dirt, grease, or chemicals, use carburetor spray or other cleaner/degreaser.
We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
Carefully peel the adhesive backing off the Thermaflect Tape stick and go!
This heat shield tape reflects up to 90% of radiant heat away from wires, lines, cables, hoses, and more! It is an excellent way to insulate components without dis-assembly, or it may be used as a means to hold other thermal insulation in place. Thermaflect Tape is also excellent as a quick on the go solution to heat problems. Our heat shield tape is a must have for your race track tool box! Durable cloth construction makes it longer lasting and more rugged than similar products. This reflective heat shield tape withstands 1100-degrees Fahrenheit continuous radiant heat (requires minimum of 1 inch of airspace) and 500-degrees Fahrenheit of direct contact. The reflective heat shield tape cuts easily and installation is simple with our high temperature self-adhesive backing that sticks to any CLEAN surface. Wider heat shield tape rolls available up to 150 feet long, minimums will apply.
